试验研究

过滤式厌氧折流反应器处理焦化废水研究

展开
  • 安徽工业大学环境与化工学院, 安徽马鞍山 243002
胡小兵(1966- ),1998年毕业于杭州大学,硕士,讲师.联系电话:0555-2486537,E-mail:hxb1612@163.net.

收稿日期: 2001-07-10

  网络出版日期: 2010-10-01

Study on the coal carbonization wastewater treatment with the anaerobic baffled filter reactor

Expand
  • College of Chemical Engineering and Environment, Anhui University of Technology, Maanshan 243002, China

Received date: 2001-07-10

  Online published: 2010-10-01

摘要

试验运用过滤式厌氧折流反应器(FABR)对焦化废水进行处理。结果表明:采用颗粒活性炭作为挂膜载体时,小粒径(0.45~0.90mm)优于大粒径(0.90~3.00mm),利于FABR快速挂膜启动;进水COD质量浓度中等(1600~2500mg/L),COD容积负荷小于2kg/(m3·d),水力停留时间大于40h,温度在34~38℃范围内,pH为7~7.6时,COD和NH3-N去除率均可达70%。厌氧处理后可提高焦化废水的可生化性,再经好氧处理,COD和NH3-N去除率均可达85%以上。

本文引用格式

胡小兵, 钟梅英 . 过滤式厌氧折流反应器处理焦化废水研究[J]. 工业水处理, 2002 , 22(1) : 31 -33 . DOI: 1011894/1005-829x.2002.22(1).31

Abstract

the coal carbonization wastewater is treated with the anaerobic baffled filter reactor(FABR), the the smaller diameter of GAC(0.45~ 0.90mm)is better for FABR tofix film.When the inf luent concentration COD =1600 ~ 2500mg/ L,COD volume load <2 kg/(m3·d).

参考文献

[1] 俞汉青,顾国维.生物膜反应器挂膜方法的试验研究[J].中国给水排水,1992,8(3):13—17.
[2] 魏复盛,等.水和废水监测分析方法指南(中册)[M].北京:中国环境科学出版社,1990:446—451.
[3] 国家环保局.水和废水监测分析方法[M].北京:中国环境科学出版社,1997:102—104.
[4] 周平,王世和.生物膜厚度对流化床反应器性能影响分析[J].环境科学,1994,15(2):1—5.

文章导航

/