经验交流

混凝-缺氧-好氧工艺处理纺织印染废水

展开
  • 1. 国家工业水处理工程技术研究中心, 天津 300131;
    2. 宜兴乐祺纺织印染有限公司, 江苏宜兴 214200
郑书忠(1956- ), 1982 年毕业于天津大学化学系, 现任国家工业水处理工程技术研究中心主任, 高级工程师, 享受国家政府津贴。

收稿日期: 2000-05-06

  网络出版日期: 2010-10-01

Treatment of textile printing and dyeing wastewater by coagulation-anoxia-aerobe technology

Expand

Received date: 2000-05-06

  Online published: 2010-10-01

摘要

采用混凝-水解酸化-生物接触氧化工艺流程处理纺织印染废水,处理量4000m3/d。进水CODCr1000~3000mg/L、色度512~1024倍、pH11~13。从1998年7月开始运行至今,CODCr平均去除率为92.32%,色度平均去除率为92.19%,出水pH值为7,出水各项指标均符合《纺织染整工业水污染物排放标准》GB4287-1992一级标准的要求,运行结果表明,该工艺处理效果稳定、耐冲击负荷强、工艺组合合理。

本文引用格式

郑书忠, 王忠诚, 徐庆源, 张艳芳, 戴瑞泉, 季青 . 混凝-缺氧-好氧工艺处理纺织印染废水[J]. 工业水处理, 2000 , 20(8) : 33 -36 . DOI: 10.11894/1005-829x.2000.20(8).33

Abstract

Textile printing and dyeing wastewater is treated with coagulationhy drolyt icacidification, and biological contact oxidation process: treating quantity 4000m3/d, inflow CODCrvalue is 1000~3000mg/L, chromaticity value is 512~1024 times, pH is 11~13. From its running in July, 1998 til now,the average removal efficiencies of CODCr and chromaticity are 92. 32% and 92. 19% respect ively, and pH of effluent value is 7. All the quality indexes of the treated water fit Grade One requir ement of 《Discharge Standard of Indust rial Wateqr Pollution of Printing and Dyeing》(GB4287-1992). The running results show that the treatment efficiency of the technology is stable, tolerable shock load range is wide and the combination of processes is reasonable.

参考文献

[1] 韩小清, 等. 厌氧-好氧-生物活性炭-纤维球过滤处理印染废水试验研究[J]. 中国给水排水, 1994, 10(4) : 29.
[2] 沈东升, 等. 我国印染废水处理技术的现状和发展趋势[J]. 环境污染与防治, 1996, 18(1) : 26.
[3] 陈新宇, 等. 难降解有机物的水解-酸化预处理[J]. 化工环保,1996, 16(3) : 152.

文章导航

/