INDUSTRIAL WATER TREATMENT ›› 1999, Vol. 19 ›› Issue (3): 14-16. doi: 10.11894/1005-829x.1999.19(3).14

Previous Articles     Next Articles

STUDY ON PROJECT APPLICATION OF THE NEW PROCESS IN TREATING THE BIOREFRACTORY WASTEWATER FROM A VELVET PRINTING AND DYEING PLANT

Xiao Yutang1   

  1. Tongji University, Shanghai 200092
  • Received:1998-12-07 Online:1999-05-20 Published:2014-08-22

难生化降解的某丝绒印染废水处理新工艺(A/O2)工程应用研究

肖羽堂1, 许建华1, 陈伟1, 李敏1, 张东1, 王冠平1, 吴玉民2, 王立庆2, 吴昊2   

  1. 1. 同济大学环境科学与工程学院, 上海 200092;
    2. 苏净集团公司净化研究所
  • 作者简介:肖羽堂,1969年生,现为同济大学环境科学 与工程学院博士。

Abstract:

The effluent of the conventional system treating the wastewater by the biocontact oxidation process cannot satisfy the national standards of sewage discharge and is above 400 mg/L and 200 multiple for COD and colority respectively under the condition of COD 817~1 930 mg/L, colority 229~800 multiple and SS 542~1 000 mg/L for the wastewater being biorefractory and varying greatly in a velvet printing and dyeing plant. The old biological treatment system is reformed in anoxic/two-grade aerobic biological process. The effluent of the reformed system can meet the requirements of first grade standards of national sewage discharge with the COD 69 mg/L, colority 40 multiple and SS 17 mg/L.

Key words: printing and dyeing wastewater, anoxic/two-grade aerobic process, biorefractory wastewater

摘要:

某丝绒印染废水难生化降解、水质多变,CODCr、色度和SS分别为817~1930mg/L、229~800倍和542~1000mg/L.采用传统的生物接触氧化-气浮组合处理工艺系统,出水CODCr和色度分别在400mg/L和200倍以上,远不能达国家污水排放标准;应用缺氧/二级好氧废水处理新工艺对原生化系统进行改造后,出水CODCr、色度和SS分别小于69mg/L,40倍和17mg/L,达国家太湖流域污水一级排放标准

关键词: 印染废水, 难降解有机物, 缺氧/二级好氧(A/O~2)工艺, 生物处理