INDUSTRIAL WATER TREATMENT ›› 2009, Vol. 29 ›› Issue (3): 40-42. doi: 10.11894/1005-829x.2009.29.(03).40

Previous Articles     Next Articles

Photocatalytic degradation of lincomycin wastewater by TiO2 catalysis

Liu Xinyu1, Zhang Dongsheng1, Zhang Lihua2, ZhaoQing2, Jia Xincheng1, Chen Hongge1   

  1. 1. College of Life Science,Henan Agricultural University,Zhengzhou 450002, China;
    2. Nanyang Pukang Pharmaceutical Co.,Ltd.,Nanyang 473053, China
  • Received:2008-11-20 Online:2009-03-20 Published:2010-10-01

TiO2光催化降解林可霉素废水的研究

刘新育1, 张东升1, 张立华2, 赵晴2, 贾新成1, 陈红歌1   

  1. 1. 河南农业大学生命科学学院,河南郑州 450002;

    2. 南阳普康药业有限公司,河南南阳 473053
  • 作者简介:刘新育(1976- ),2003 年毕业于河南农业大学,硕士,讲师,E-mail:honggeyz@163.com。
  • 基金资助:

    河南省科技攻关项目(2008A180010)

Abstract:

Using a 250 W ultraviolet lamp as the light source, TiO2 as catalyst,the conditions of photocatalyticdegradation of lincomycin have been investigated. The results show that when the TiO2 dosage is 0.4 g/L,the solutionpH 5.0, the initial lincomycin concentration 60 mg/L and the photo reaction time 90 min, the degradation rateof lincomycin could reach 100%. The experiments also demonstrate that when the composite TiO2 is doped with 1%of Cu2+,its photocatalytic activity is higher than pure TiO2. When this optimized photocatalytic degradation systemis used for treating lincomycin wastewater, Lincomycin can be removed completely from the wastewater.

Key words: lincomycin, TiO2, photocatalysis

摘要:

以250 W紫外灯作光源,以TiO2为催化剂,研究了林可霉素光催化降解的合适条件。结果表明,在TiO2用量为0.4 g/L,pH为5.0,林可霉素初始质量浓度为60 mg/L,光催化反应90 min的条件下,林可霉素降解率达到100%。掺杂1%(以物质的量计)Cu2+的TiO2复合催化剂,其光催化活性高于纯TiO2。将优化的光催化降解体系用于林可霉素生产厂废水的处理,可实现林可霉素的完全去除。

关键词: 林可霉素, TiO2, 光催化

CLC Number: