工业水处理 ›› 2017, Vol. 37 ›› Issue (5): 79-82. doi: 10.11894/1005-829x.2017.37(5).079

• 试验研究 • 上一篇    下一篇

预氧化-MBR-反渗透工艺深度处理印染废水研究

朱兆亮1, 崔山1,2, 葛孝新3, 田庆余3, 刘昌明1   

  1. 1. 山东建筑大学市政与环境工程学院, 山东济南 250101;
    2. 中国水环境集团, 山东青岛 266399;
    3. 高密市孚日自来水有限公司, 山东潍坊 261500
  • 收稿日期:2017-03-19 修回日期:2017-03-19 出版日期:2017-05-20 发布日期:2017-06-03
  • 作者简介:朱兆亮(1975-),博士,副教授。E-mail:262263065@qq.com。

Research on the advanced treatment of printing and dyeing wastewater by pre-oxidation-MBR-reverse osmosis process

Zhu Zhaoliang1, Cui Shan1,2, Ge Xiaoxin3, Tian Qingyu3, Liu Changming1   

  1. 1. School of Municipal and Environmental Engineering, Shandong Jianzhu University, Shandong 250101, China;
    2. China Water Environment Group, Shandong 266399, China;
    3. Gaomi City Furitap Water Co., Ltd., Shandong 261500, China
  • Received:2017-03-19 Revised:2017-03-19 Online:2017-05-20 Published:2017-06-03

摘要:

以某工业园区印染废水处理厂二级生化出水为处理对象,采用预氧化+膜生物反应器(MBR)+反渗透(RO)的组合工艺对其进行深度处理,以达到企业回用水要求。实验结果表明,在进水COD为105~120 mg/L,色度为50倍的条件下,当氧化剂用量为3 mg/L,MBR水力停留时间为3~3.5 h时,组合工艺的出水COD ≤ 5 mg/L,色度≤ 5倍,电导率≤ 20μS/cm,出水水质满足企业回用水要求,RO浓水COD ≤ 120 mg/L,色度≤ 50倍,达到排放标准。

关键词: 印染废水, 氧化剂, MBR, 反渗透

Abstract:

Taking the secondary biological treatment effluent of a dyeing wastewater treatment plant in an industrial zone as the treatment object,the combined process,pre-oxidation-membrane bioreactor(MBR)-reverse osmosis, has been used for its advanced treatment,in order to meet the requirements for the industrial reuse water. Experimental results show that under the conditions below:the influent COD is 105-120 mg/L,chroma 50 times,the dosage of oxidant 3 mg/L,and MBR hydraulic residence time 3-3.5 h,the effluent COD of the combined process is ≤ 5 mg/L,chroma ≤ 5 times,and conductivity ≤ 20 μS/cm,the effluent water quality meets the requirements for the industrial water reuse. RO concentrated water COD is ≤ 120 mg/L and chroma ≤ 50 times,achieving the discharge standard.

Key words: dyeing wastewater, oxidation agent, membrane bioreactor, reverse osmosis

中图分类号: