工业水处理 ›› 2025, Vol. 45 ›› Issue (10): 183-190. doi: 10.19965/j.cnki.iwt.2024-0896

• 试验研究 • 上一篇    

基于一体化PN/A工艺处理沼液的前处理工艺研究

陈锦财1,2,3(), 张连2, 王思琦2, 刘淑杰1,2,3(), 黎紫江2, 邓昭滨2, 罗泳翔2, 李艳红1,3   

  1. 1. 桂林理工大学,广西岩溶地区水污染控制与用水安全保障协同创新中心,广西 桂林 541006
    2. 清研环境科技股份有限公司,广东 深圳 518057
    3. 桂林理工大学,广西环境污染控制理论与技术重点实验室,广西 桂林 541006
  • 收稿日期:2025-02-24 出版日期:2025-10-20 发布日期:2025-11-05
  • 通讯作者: 刘淑杰
  • 作者简介:

    陈锦财(1999— ),硕士研究生,E-mail:

Study on pre-treatment processes for biogas slurry treatment based on integrated PN/A process

Jincai CHEN1,2,3(), Lian ZHANG2, Siqi WANG2, Shujie LIU1,2,3(), Zijiang Li2, Zhaobin DENG2, Yongxiang LUO2, Yanhong LI1,3   

  1. 1. Collaborative Innovation Center for Water Pollution Control and Water Safety in Karst Area, Guilin University of Technology, Guilin 541006, China
    2. Qingyan Environmental Technology Co. , Ltd. , Shenzhen 518057, China
    3. Guangxi Key Laboratory of Theory and Technology for Environmental Pollution Control, Guilin University of Technology, Guilin 541006, China
  • Received:2025-02-24 Online:2025-10-20 Published:2025-11-05
  • Contact: Shujie LIU

摘要:

餐厨沼液中COD高导致C/N偏高,直接采用一体化短程硝化-厌氧氨氧化(PN/A)工艺处理易引起异养菌累积导致系统失稳问题。对此,设计试验分析对比混凝沉淀、厌氧消化和缺氧/好氧(A/O)3种前处理工艺对餐厨沼液COD及其他污染物的去除效果,考察C/N的变化,同时结合工艺应用优劣势,明确最佳前处理工艺,并进一步考察该前处理工艺联合一体化PN/A工艺长期运行的效果和稳定性。结果表明,A/O工艺表现出最佳的前处理效果,COD去除率超过65%,明显优于混凝沉淀工艺(26.0%)和厌氧消化工艺(60.1%),且出水C/N稳定低于1。此外,A/O工艺运维简单,工艺运行稳定,且能去除11%的TN。因此,选定A/O工艺为前处理工艺。在A/O-PN/A联动试验中,即使在进水C/N波动的条件下,A/O工艺仍能将出水C/N稳定维持在0.8±0.1,确保PN/A系统稳定运行。组合工艺对NH4 +-N和TN的去除率分别稳定达到90%和85%以上。与传统的两级A/O工艺相比,A/O-PN/A组合工艺具有无碳源投加、节省曝气能耗和占地面积的优势,为餐厨沼液等高氨氮废水的处理提供了一条经济、高效且低碳的技术路径。

关键词: 沼液, C/N, 短程硝化, 厌氧氨氧化, 高氨氮废水

Abstract:

The high COD concentration in food waste biogas slurry leads to a high C/N ratio. Directly applying the integrated partial nitrification-anammox(PN/A) process for treatment can easily cause the accumulation of heterotrophic bacteria and process instability. To address, the experimental design involved analyzing and comparing the removal efficiencies of COD and other pollutants in food waste biogas slurry by three pretreatment processes: coagulation-sedimentation, anaerobic digestion, and anoxic/oxic (A/O). The changes of C/N ratio were investigated, and the optimal pretreatment process was determined based on the advantages and disadvantages of the processes. Furthermore, the long-term operational effect and stability of the combined pretreatment process and integrated PN/A process were explored. The results showed that the A/O process exhibited the best pretreatment effect, with COD removal rate of exceeding 65%, which was significantly higher than the coagulation-sedimentation process (26.0%) and anaerobic digestion process (60.1%), and the effluent C/N remained stable below 1. In addition, the A/O process had simple operation and maintenance, stable process operation, and could remove 11% of TN. Therefore, the A/O process was selected as the most suitable pretreatment process. In the A/O-PN/A linkage test, even under the condition of fluctuating influent C/N, the A/O process could still maintain the effluent C/N stable at 0.8±0.1, ensuring the stable operation of the PN/A system. The combined process could achieve stable removal rates of over 90% and 85% for NH4 +-N and TN, respectively. Compared with the traditional two-stage A/O process, the A/O-PN/A combined process had the advantages of no carbon source addition, reduced aeration energy consumption and land area, providing an economical, efficient and low-carbon technical path for the treatment of high ammonia-nitrogen wastewater such as food waste biogas slurry.

Key words: biogas slurry, C/N ratio, partial nitritation, anaerobic ammonium oxidation, high ammonia-nitrogen wastewater

中图分类号: