INDUSTRIAL WATER TREATMENT ›› 2011, Vol. 31 ›› Issue (9): 88-90. doi: 10.11894/1005-829x.2011.31(9).88

Previous Articles     Next Articles

Treatment of highly concentrated wastewater from membrane making by coagulation-UASB-biological contact oxidation process

Chen Weiping   

  1. Nantong Development Zone Wastewater Treatment Plant, Nantong 226009, China
  • Received:2011-06-24 Revised:2011-06-24 Published:2011-09-29

混凝-UASB-生物接触氧化处理制滤膜高浓度废水

陈卫平   

  1. 南通开发区污水处理厂, 江苏南通 226009
  • 作者简介:陈卫平(1969- ),1991 年毕业于江苏化工学院,工程师, 副厂长。E-mail:cwp_cwp@yeah.net。

Abstract:

The coagulation -UASB -biological contact oxidation process has been used for treating the highlyconcentrated organic wastewater from membrane making. The applied results show that when the COD、BOD5 and SSof influent are 15 000,7 000,400 mg/L respectively,the removal rates of the three are all above 80%. The effluentwater quality is stable and meet the third class of Integrated Wastewater Discharge Standard(GB 8978-1996). The effluent water finally discharges into the wastewater treatment plant in Nantong Development Zone.

Key words: wastewater from membrane making, up-flow anaerobic sludge bed, biological contact oxidation

摘要:

采用混凝-UASB-生物接触氧化工艺对制滤膜过程中产生的高浓度有机废水进行处理。工程运行结果表明,在进水COD、BOD5、SS分别为15 000、7 000、400 mg/L的条件下,三者的去除率均在80%以上,出水水质达到GB 8978-1996《污水综合排放标准》的三级标准要求,尾水最终排入南通开发区污水处理厂。

关键词: 滤膜生产废水, UASB, 生物接触氧化

CLC Number: