工业水处理 ›› 2009, Vol. 29 ›› Issue (7): 47-50. doi: 10.11894/1005-829x.2009.29.(7).47

• 实验研究 • 上一篇    下一篇

TiO2催化串联电极法在染料废水处理中的应用

刘弋潞, 卢维奇, 曹桂清   

  1. 佛山科学技术学院理学院, 广东佛山 528000
  • 收稿日期:2009-03-10 修回日期:2009-03-11 出版日期:2009-07-20 发布日期:2010-10-01
  • 作者简介:刘弋潞(1967- ),1989年毕业于南昌大学(原为江西工业大学),高级实验师,讲师.电话:13620139369,E-mail:lyl1300@sina.com

Application of TiO2 cascade catalytic electrode to the treatment of dyestuff wastewater

Liu Yilu, Lu Weiqi, Cao Guiqing   

  1. College of Science, Foshan University, Foshan 528000, China
  • Received:2009-03-10 Revised:2009-03-11 Online:2009-07-20 Published:2010-10-01

摘要:

联合使用TiO2催化串联电极法和絮凝法处理染料废水.研究结果表明:在电压为9V、电极间距1.0cm、电解时间90min、pH为5~6的最佳处理条件下,使用TiO2催化串联电极法处理南方印染有限公司的废水,其脱色率达到96.0%以上,COD降解率在80.0%左右.该方法比传统方法处理效果好、适用范围广、应用前景广阔.

关键词: 催化, 电解氧化, 二氧化钛, 印染废水

Abstract:

Dyestuff wastewater has been treated by TiO2 cascade catalytic electrode and coagulation method.The results show that when the electric pressure is 9 V,electrode distant 1.0 cm,electrolysis time 90 min and pH ranges from 5 to 6,TiO2 cascade catalytic electrode is used for treating the wastewater in the South Printing and Dyeing Co.,Ltd.Its decolorization rate can be over 96.0% and the removal rate of COD is around 80.0% under the optimum conditions.It is better than traditional methods, having wider adjustability and application prospect.

Key words: catalysis, electrolytic oxidation, TiO2, printing and dyeing wastewater

中图分类号: