工业水处理 ›› 2009, Vol. 29 ›› Issue (6): 69-71. doi: 10.11894/1005-829x.2009.29(6).69

• 经验交流 • 上一篇    下一篇

某造纸厂废水处理改造工程设计实例

时鹏辉, 罗领先, 李江   

  1. 河南城建学院环境工程系,河南平顶山467044
  • 收稿日期:2009-02-10 出版日期:2009-06-20 发布日期:2010-10-01
  • 作者简介:时鹏辉(1980- ),2007 年毕业于中国矿业大学,硕士。电话:15836971123,E-mail:sphylx@163.com

Design of the reform engineering of wastewater treatment of a paper making plant

Shi Penghui, Luo Lingxian, Li Jiang   

  1. Environmental Engineering Department, Henan University of Urban Construction,Pingdingshan 467044, China
  • Received:2009-02-10 Online:2009-06-20 Published:2010-10-01

摘要:

河南某造纸厂废水处理采用收浆+调节池+超效浅层气浮工艺,出水不达标。在原有工艺的基础上增加接触 氧化池,完善了物化处理+生化处理的工艺流程。运行结果表明:用该工艺处理造纸废水,其出水水质达到《造纸工业水 污染物排放标准》(GB 3544—2001)中的要求。

关键词: 造纸废水, 接触氧化, 气浮

Abstract:

Slurry collecting + adjusting pool + highly effective shallow gas floatation technology had been used at a paper-making plant in Henan Province, but the effluent did not reach the national discharge standard. On the basis of the original technology, the contact oxidation pool is added, so as to complete the optimum physical chemistry treatment + biochemical treatment process. The running results show that the effluent water meets the demands of the Standard of Pollutants Discharge for Paper Making Wastewater Treatment (GB 3544—2001).

Key words: paper making wastewater, contact oxidation, air floatation

中图分类号: