INDUSTRIAL WATER TREATMENT ›› 2011, Vol. 31 ›› Issue (4): 30-33. doi: 10.11894/1005-829x.2011.31.(4).30

Previous Articles     Next Articles

Research on the performance recovery of deeply polluted strong acidic cation resin in industrial water treatment systems

Huang Bo ,Li Yongsheng   

  1. School of Chemical Engineering, Sichuan University, Chengdu 610065, China
  • Received:2010-12-06 Revised:2010-12-06 Online:2011-04-20 Published:2011-04-13

强阳树脂深度污染后的性能复苏研究

黄波, 李永生   

  1. 四川大学化学工程学院四川成都610065
  • 作者简介:黄波(1985- ),四川大学在读研究生。

Abstract:

The recovery of deeply polluted strong acidic cation exchange resin(SACR) has been researched by using the SACR performance determination system based on flow-injection (FI)/sodium ion selective electrode (Na-ISE). In order to get deeply polluted SACR,the SACR is to be immersed in a saturated tri-chloride ferric solution and a kind of lubricant oil, and dried at 110 ℃ for 6 h. Then,various recovery factors are examined in the SACR system of FI-Na-ISE. The optimized recovery conditions are as follows:recovery temperature is 31 ℃,the mass fraction of HCl,NaCl,Na2SO3 in the recovery agent are 3.0%,3.0% and 2.0% respectively,the flow speed of recovery agent is 1.0 mL/min,and its dosage is 300 mL/g. Under optimized conditions,the deeply polluted SACR is to be recovered continuously,the equilibrium exchange capacity of the resin can be recovered from the former 2.237 mmol/g to 3.531 mmol/g,reaching 89.0% of the equilibrium exchange capacity of the new type of resin,so as to realized its reusing

Key words: strong acidic cationic exchange resin, deeply polluted resin, flow injection, sodium ion selective electrode, recovery

摘要:

针对工业深度污染的强酸型阳离子交换树脂(SACR),采用基于流动注射-钠离子选择电极(FI-Na-ISE)的SACR性能测定系统,进行了对深度污染SACR的复苏研究。首先将SACR用饱和FeCl3溶液、润滑油浸泡,并在110℃干燥6 h,制得深度污染SACR。然后在FI-Na-ISE的SACR性能测定系统中对各种复苏因素进行考察。优选出的复苏条件是:复苏温度31℃,复苏剂中HCl、NaCl、Na2SO3质量分数分别为3.0%、3.0%、2.0%,复苏剂流速为1.0 mL/min,用量为300 mL/g。在优化条件下,对深度污染SACR进行连续动态复苏,使树脂的平衡交换容量从复苏前的2.237 mmol/g恢复至3.531 mmol/g,达到同型号新树脂平衡交换容量的89.0%,从而实现其再利用。

关键词: 强酸型阳离子交换树脂, 深度污染树脂, 流动注射, 钠离子选择电极, 复苏

CLC Number: