INDUSTRIAL WATER TREATMENT ›› 2011, Vol. 31 ›› Issue (11): 38-41. doi: 10.11894/1005-829x.2011.31(11).38

Previous Articles     Next Articles

Pretreatment of wastewater containing highly concentrated anionic surfactant by micro-electrolysis

Wen Shanxiong1, Liang Baofeng1, Xu Jing2, Rong Shumao1   

  1. 1. Lanzhou Petrochemical Research Center, Petrochina, Lanzhou 730060, China;
    2. Synthetic Rubber Factory of Lanzhou Petrochemical Co., Petrochina, Lanzhou 730060, China
  • Received:2011-07-18 Online:2011-11-21 Published:2011-11-22

微电解法预处理高浓度阴离子表面活性剂废水

文善雄1, 梁宝锋1, 徐静2, 荣树茂1   

  1. 1. 中国石油兰州化工研究中心, 甘肃兰州 730060;
    2. 中国石油兰州石化公司合成橡胶厂, 甘肃兰州 730060
  • 作者简介:文善雄(1978- ),2001年毕业于江汉石油学院,工程师.电话:13919134649
  • 基金资助:

    中国石油天然气股份有限公司科技管理部资助项目(2008D-4707)

Abstract:

The pretreatment effect of the wastewater containing highly concentrated anionic surfactant (AS) by different micro-electrolysis modes has been investigated. The results show that under the same conditions:the mass ratio of F3(iron,size 3 mm×10 mm) and C3(activated carbon,size D 2 mm×3 mm) is 2∶1, pH 3.5 and retention time 30 min,the average removing rates of AS and COD are 51.32% and 48.9%,respectively by binary microelectrolysis.When the mass ratio of F3、Cu and C3 is 60 ∶60 ∶40,the average removing rates of AS and COD are 54.14% and 49.0%,respectively by ternary micro-electrolysis. Out of consideration for the treatment effectiveness and actual application,the binary micro-electrolysis should be selected for the pretreatment of such wastewater.

Key words: micro-electrolysis, anionic surfactant, wastewater treatment

摘要:

考察了不同微电解方式对含高浓度阴离子表面活性剂(AS)废水的预处理效果,结果表明,在铁炭填料分别为F3(铁屑,规格3 mm×10 mm)、C3(活性炭,规格D 2 mm×3 mm),进水pH为3.5,停留时间为30 min的相同条件下,当m(F3)∶m(C3)=2∶1时,二元微电解法对废水AS及COD的平均去除率分别为51.32%、48.9%;当m(F3)∶m(Cu)∶m(C3)=60∶60∶40时,三元微电解法对废水AS及COD的平均去除率分别为54.14%、49.0%。从处理效果和实际工程应用综合考虑,选用二元微电解法预处理该废水。

关键词: 微电解, 阴离子表面活性剂, 废水处理

CLC Number: