INDUSTRIAL WATER TREATMENT ›› 2012, Vol. 32 ›› Issue (10): 61-64. doi: 10.11894/1005-829x.2012.32(10).61

Previous Articles     Next Articles

Experimental research on the removal of nitrogen from PU synthetic leather wastewater by combined process anaerobic MBBR and aerobic MBR

Wang Qing1,2, Ding Yuanhong1,2, Ren Hongqiang1,2, Liu Minmin2, Hao Lizhi3, Yang Qian3   

  1. 1. Key Lab of Pollution Control and Resources Reuse, Nanjing University, Nanjing 210093, China;
    2. Nanjing University Yixing Environmental Research Institute, Yixing 214200, China;
    3. Huashu Pharmaceutical Co., Ltd., Shijiazhuang 050031, China
  • Received:2012-07-05 Online:2012-10-20 Published:2012-11-15

厌氧MBBR-好氧MBR组合工艺对PU合成革废水的除氮试验研究

王庆1,2, 丁原红1,2, 任洪强1,2, 刘敏敏2, 郝立志3, 杨倩3   

  1. 1. 南京大学污染控制与资源化国家重点实验室, 江苏南京 210093;
    2. 南京大学宜兴环保研究院,江苏宜兴 214200;
    3. 石家庄华曙制药集团有限公司,河北石家庄 050031
  • 作者简介:王庆(1972- ),硕士,高级工程师。电话:13952566365。

Abstract:

The biochemical effluent water from Fuyang Xingye Synthetic Leather Co.,Ltd.,is characterized by comparatively low COD,high nitrogen content,and wide fluctuation range.The biochemical combined process anaerobic MBBR-aerobic MBR has continuously been used for treating synthetic leather wastewater for four months,in Fuyang Xingye Synthetic Leather Co.,Ltd.,Hangzhou.The experimental results indicates that its COD can steadily reach the mark,and the effluent ammonium nitrogen are steadily maintained between 7.46-13.82 mg/L,as well,meeting the requirements of the Discharge Standard of Pollutants from Synthetic Leather and Artificial Leather Industry(GB 21902-2008).

Key words: synthetic leather wostewate, anaerobic MBBR, aerobic MBR

摘要:

杭州富阳兴业合成革有限公司的生化工艺出水COD相对较低,含氮量较高,且波动较大。采用厌氧MBBR-好氧MBR组合工艺对该废水进行了4个月的连续处理试验,结果表明:除COD可稳定达标外,出水氨氮也可稳定维持在7.46~13.82 mg/L之间,达到《合成革与人造革工业污染物排放标准》(GB 21902-2008)要求。

关键词: 合成革废水, 厌氧MBBR, 好氧MBR

CLC Number: