工业水处理 ›› 2021, Vol. 41 ›› Issue (1): 130-135. doi: 10.11894/iwt.2020-0031

• 工程实例 • 上一篇    下一篇

印染废水处理改造及污泥减量化的设计与运行

徐锋()   

  1. 浙江大学能源工程设计研究院有限公司, 浙江杭州 310027
  • 收稿日期:2020-11-25 出版日期:2021-01-20 发布日期:2021-01-27
  • 作者简介:徐锋(1984-), 本科, 工程师。E-mail:13732230961@126.com

Design and operation of printing and dyeing wastewater treatment and sludge reduction

Feng Xu()   

  1. Energy Engineering Design and Research Institute of Zhejiang University Company Limited, Hangzhou 310027, China
  • Received:2020-11-25 Online:2021-01-20 Published:2021-01-27

摘要:

针对印染废水处理中总氮与总锑难达标、产泥量大等问题,采用物化+厌氧+兼氧+两段好氧+物化工艺进行改造,改造后出水各指标均达到《纺织染整工业水污染物排放标准》(GB 4287-2012)间接排放要求,且废水处理站的产泥量较改造前缩减了50%。工程实践表明,该工艺具有处理效果好、运行稳定、污泥减量效果显著、改造简单易行等优势。

关键词: 印染废水, 脱氮, 除锑, 污泥减量化

Abstract:

There exist some issues such as total nitrogen and antimony difficult to meet the standard, large amount of mud production and etc in the current printing and dyeing wastewater treatment. In view of that, an improved process combined with physiochemical, anaerobic, facultative anaerobic, two sections aerobic and physical and chemical processwas employed, and the water emission indicators were up to the indirect discharge requirements of Textile Dyeing and Finishing Industrial Water Pollutant Emission Standards(GB 4287-2012). Moreover, the amount of mud produced in wastewater treatment stations was reduced by 50% compared with before the improvement. Engineering practice showed that the improved process had the advantages of good treatment, stable operation, remarkable effect of sludge reduction, simple and easy upgrade.

Key words: printing and dyeing wastewater, denitrification, removal of antimony, sludge reduction

中图分类号: